Zoning Districts Guide Commercial Districts C1 C2 Overlays Dcp C1 1 through c1 5 and c2 1 through c2 5 districts are commercial overlays mapped within residence districts. mapped along streets that serve local retail needs, they are found extensively throughout the city’s lower and medium density areas and occasionally in higher density districts. typical retail uses include neighborhood grocery stores. There are only minor differences between c1 and c2 districts, with a slightly wider range of uses permitted in c2 districts, such as funeral homes and local repair services. in mixed buildings, commercial uses are limited to one or two floors and must always be located below the residential use. the maximum commercial floor area ratio (far) is 2.0.
Zoning Districts Guide Commercial Districts C1 C2 Overlays Dcp Residential uses and use group 3 community facilities are prohibited in c8 districts. the eight commercial districts are subdivided (as indicated by a numerical suffix) to reflect variations in bulk and parking and loading requirements. the floor area ratio (far) for a c4 1 district, for example, is 1.0 while the far for a c4 7 district is 10.0. Zoning maps show the boundaries of zoning districts throughout the city. the maps are regularly updated after the city planning commission and the city council have approved proposed zoning changes. the set of 126 maps, which are part of the zoning resolution, are displayed in 35 sections. each section is identified by a number from 1 to 35 and. The maximum commercial floor area ratio (far) ranges from 4.0 to 15.0, and the maximum residential far is 10.0. floor area may be increased by a bonus for a public plaza or inclusionary housing. in the two contextual c5 districts—c5 1a and c5 2a—residential bulk and density are governed by r10a regulations. in non contextual c5 2 through c5. C3 and c3a districts also permit residences and community facilities (use groups 1–4). c3a districts are mapped in staten island and the throgs neck area of the bronx. c3 districts are found on city island and along mill basin in brooklyn. the commercial floor area ratio (far) permitted in c3 districts is 0.5.
Zoning Districts Guide Commercial Districts C1 C2 Overlays Dcp The maximum commercial floor area ratio (far) ranges from 4.0 to 15.0, and the maximum residential far is 10.0. floor area may be increased by a bonus for a public plaza or inclusionary housing. in the two contextual c5 districts—c5 1a and c5 2a—residential bulk and density are governed by r10a regulations. in non contextual c5 2 through c5. C3 and c3a districts also permit residences and community facilities (use groups 1–4). c3a districts are mapped in staten island and the throgs neck area of the bronx. c3 districts are found on city island and along mill basin in brooklyn. the commercial floor area ratio (far) permitted in c3 districts is 0.5. Chapter 4: commercial districts) commercial overlay a c1 or c2 district mapped within residence districts to accommodate local retail and services (grocery stores, dry cleaners, restaurants, for example). ˜ese districts, designated by the letters c1 1 through c1 5 and c2 1 through c2 5, appear on the zoning map as a pattern superimposed on a. The property is located within a commercial overlay district, speciƒcally a c1 4 district. on the map he does not see a grey tone over the property, so it is not in a special purpose district. additionally, it is not located near the waterfront, an airport or any of the other areas where special zoning rules apply, so the standard zoning.
Zoning Districts Guide Commercial Districts C1 C2 Dcpођ Chapter 4: commercial districts) commercial overlay a c1 or c2 district mapped within residence districts to accommodate local retail and services (grocery stores, dry cleaners, restaurants, for example). ˜ese districts, designated by the letters c1 1 through c1 5 and c2 1 through c2 5, appear on the zoning map as a pattern superimposed on a. The property is located within a commercial overlay district, speciƒcally a c1 4 district. on the map he does not see a grey tone over the property, so it is not in a special purpose district. additionally, it is not located near the waterfront, an airport or any of the other areas where special zoning rules apply, so the standard zoning.
Comments are closed.