Where Is The Oil Pressure Switch Mazda 6 Forums Never fear, sonic is here. its under the ac compressor. not easily visible . i've added a tee fitting and capillary tube to a mechanical gauge and i've deleted my ac, but that is the stock switch & connector treaded into the tee and the tee is threaded into the original hole. good luck. Mazda 6 skyactiv d 2.2 oil pressure sensor. hello! first post here so go easy on me! i have a 2013 mazda 6 skyactiv d in the uk with 60k miles on it. last sunday the low oil pressure warning came on suddenly whilst driving and has remained on ever since, at whatever rpm the engine is. oil is full, but i changed the oil and filter just in case.
Mazda 6 Service Manual Oil Pressure Switch Inspection Automatic I have a 2014 2.2 d (175 bhp automatic) with similar issues. "oil pressure low possible engine damage". as a first action the garage checked the oil and eventually fully replaced it. it seemed fine, also no pollution found in the oil, which one would expect with severe engine damage. I have the special mazda socket for the knock sensor, and it is the exact same needed to pull the switch. easy enough, but, i bought a replacement switch from oreilly auto parts, and, murphy's law, it took a different size socket. back to oreilly's, the common oil pressure switch socket for gm ford chrysler cars fits the replacement socket. I believe starting from 2018 cx 5 2.5l with cd, and 2019 cx 5 2.5t turbo, they have both low oil pressure warning light and low oil level warning light in dash. here's the difference between low oil pressure warning light icon and low oil level warning light icon other than red amber color difference:. Jul 29, 2015. #5. mrgiggles said: just to update this, the threads on the factory switch are 1 8 npt. since i'm not running a turbo or using the sandwich plate, i'll just use a brass tee fitting. wrong. they are not npt they are bspt. 27 threads inch versus 28 threads in.
Mazda 6 Diesel Oil Pressure Switch Location I believe starting from 2018 cx 5 2.5l with cd, and 2019 cx 5 2.5t turbo, they have both low oil pressure warning light and low oil level warning light in dash. here's the difference between low oil pressure warning light icon and low oil level warning light icon other than red amber color difference:. Jul 29, 2015. #5. mrgiggles said: just to update this, the threads on the factory switch are 1 8 npt. since i'm not running a turbo or using the sandwich plate, i'll just use a brass tee fitting. wrong. they are not npt they are bspt. 27 threads inch versus 28 threads in. Not a perfect fit but good enough for the low torque needed to get the old switch out and the new one in. switch was 6 and the socket 10 bucks; also got some teflon tape to apply around the thread. i removed two screws to be able to move the wiring harness (between engine and radiator fans) out of the way, so i could reach the oil pressure switch. Before you do anything else, check and inspect the charging system. be certain your battery is in good condition and the alternator is putting out between 13.5 and 14.5 volts at idle. rev the engine to 2000 rpm and it should hit 14.5. next, check for trouble codes with a obd 2 scanner. the oil indicator light is triggered by a drop in oil pressure.
Comments are closed.