Q A Dodge Intrepid Coolant Bleed Valve Location Justanswer 2005 dodge stratus: 2.7l coolant doesnt come out of the blead valve i just change the thermostat on a 2005 doge stratus, 2.7l engine. i opened the blead valve and filled the expansion tank to the max line, but coolant doesn't come out of the blead valve. 2004 dodge intrepid 2,7l could you explain the bleeder valve on the thermostat housing and how to bleed it. having over heating problems and coolant resevoir appears to boil or bubbles as if boiling. … read more.
Q A How To Replace Coolant Air Bleeder Valve On 2003 Dodge Intrepid Allow coolant to drain into the container until emptied. connect overflow hose to fill neck. remove special tool 8195, filling aid funnel. install cap on coolant pressure bottle. remove hose from bleed valve. note: the engine cooling system will push any remaining air into the coolant bottle within about an hour of normal driving. Find the upper radiator hose, follow it to the engine, and you will see the water outlet. the bleeder screw is right on top and in the center of it. check your water pump too since you were low on coolant. the weep hole is in the block to the lower left of the thermostat housing, which is located behind the alternator, at the end of the lower. Dodge intrepid 2nd gen (98 04) how do i replace the coolant bleed valve on a 2001 2.7 engine. do i need to remove the upper intake to access the bolts? if yes. Allow to reach operation temperature.then turn vehicle off and let cool down.top off coolant recovery bottle.the easier, non special equipment way is as follows:1. remove the cap from the overflow tank2. fill the overflow tank with coolant to the full mark3. leave the cap off and start the engine4.
Comments are closed.