How To Reset Oil Sevice Light On Hyundai I20 2018 2019о #hyundaii20 #servicereset #quickfix #diy #diytaj #carhacks #howtodoit #easyfixhyundai i20 2018how to reset oil service warning on hyundai i20how to check and. With type a screen. first insert the key and put the ignition on. click the button right here to switch through the menus and find the exclamation point or the wrench icon. next, you go down to find the service minder. then you do just click the ok button and hold it to reset.
Hyundai I20 Service Light Reset Youtube About press copyright contact us creators advertise developers terms privacy policy & safety how works test new features nfl sunday ticket press copyright. Step 4. while the service in service required is displayed, press and hold the ok button until the hold ok:reset is displayed then release the ok button then press and hold the ok button again to reset the service maintenance to the next service maintenance schedule. learn more👉 how to reset: hyundai tucson oil service maintenance light. Hyundai i20 2015 2016 2017 2018 2019 service spanner light interval reset. Remove the dipstick, wipe it clean, reinsert it, and then check the oil level. if the oil level is low, add the recommended type and amount of oil to bring it back to the proper level. restart the engine and monitor the light: after adding oil, start the engine and observe if the oil pressure warning light goes off.
Hyundai I20 Service Light Reset Youtube Hyundai i20 2015 2016 2017 2018 2019 service spanner light interval reset. Remove the dipstick, wipe it clean, reinsert it, and then check the oil level. if the oil level is low, add the recommended type and amount of oil to bring it back to the proper level. restart the engine and monitor the light: after adding oil, start the engine and observe if the oil pressure warning light goes off. Step 1: insert key into the ignition and turn the key to the “on” position. don’t start the vehicle. if you have a hyundai with a smart key, press the “start” button twice without touching the brake pedal. step 2: press “ok” if applicable. if the “service required” information pops up on the screen, press the “ok” button. Use the “odo trip” button on the dashboard to change the dashboard display to “trip a.”. turn your car off and hold down the “odo trip” button. turn your car back on so it’s just running power. continue to hold down on the “odo trip” button until the maintenance light disappears. then, release the button.
Comments are closed.