Diy Felt Flower Hair Clips With Free Pattern The Yellow Birdhouse Ok the clip. hold the clip open and add a small line of glue in the groove. take your felt circle and press it into the glue to secure. add a generous amount of glue to the underside of the clip circle and press it into the bottom of the flower making sure all the glue is adhered. all done!. Cut around the flower, then remove the shape, stick onto another piece of felt and cut out a second one. this is for the second matching clip. repeat for the other two shapes that make up your flower. layer the felt pieces on top of each other and sew together in the centre. sew onto the clip and tie tightly at the back.
Make Diy Felt Flower Hair Clips For Spring With The Magic Onions "diy hair accessory flower hair clip how nice would it be to make your own hair clips at home, isn't it? this exciting crafting hours video will show you ho. Cut the outline of the clips with an allowance of approx. 1 mm. on the back of the clip covers use a sharp pair of scissors to cut, very carefully, a slot of about 0.7 cm in length. the hair clip is now inserted here. push it into the slot as shown in the photo so that the majority of the clip is now inside the felt cover. Supplies needed: flowers. scrap of felt. glue (hot glue or something stronger like this e6000 craft glue) needle and tread. hair clips (snap clips (with hole) or alligator clips, whichever you prefer.) instructions: depending on the type of flower you are using, remove the wire and or snip off the plastic tip so the bottom of the flower is flat. You will need to cut out 4 of the flower shapes. fold the cut out flower pieces in half and in half again. then you will mentally divide the circle (with leaves on it) into quarters. each folded flower pieces will take up one corner quarter. stitch the folded corner of the flowers down toward the center of the circle.
Comments are closed.