How To Install Ridge Caps On Metal Roofing Youtube This shows you exactly how to install metal roof ridge caps. phil walks you through each job step by step so you can work on your own roof. how to diy the me. This video will show you how to install your ridge and hip caps on your metal roofing. it includes some tips to remember during this fairly simple process. g.
How To Install Standing Seam Metal Roofing Ridge Cap Unvented Youtube Learn how to install metal roof ridge cap. step by step video with metal roofing ridge cap installation instructions instructions on an exposed fastener pane. Make a mark at the cap’s lower edges (both sides), at one end of the ridge. see the illustration below. if the ridge is only 15’ 20’ long, repeat step 1 at the opposite end of the ridge. for a longer ridge, move along the ridge repeating step 1 every 15’ or so, until you reach the opposite end. set the piece of ridge cap aside, and snap. Pry open the hems to the 1 inch mark, and cut away 1 inch of the hem on both sides. mark the center of the ridge cap so that it aligns with your roof’s slope using a speed square and a. Watch the video. mark the center of the ridge cap based upon the angle of the protractor. cut the ridge cap. use a hand seamer and fold the uncut left side 90 degrees. fold the cut right side down 90 degrees. there is no easy way to describe in words how to prepare the edge of the ridge cap for the gable ends.
Comments are closed.