How To Install Lay Carpet 6 Easy Steps Flooring America Step 6: stretching and attaching the carpet. to finish the installation, the carpet must be stretched using first a “knee kicker” and then a carpet spreader to attach to the tackless strips along each wall. stretching should be followed up by final wall trimming, tucking at the walls, and reinstallation of the molding at the baseboards. Slide a length of heat activated seam tape halfway underneath the edge of carpeting that’s flat on the floor. run the tape along the entire seam, making sure it’s positioned halfway under the carpeting. lay flat the folded back piece of carpeting and check for a tight fit along the seam.
How To Install Lay Carpet 6 Easy Steps Flooring America Place the tooth edge of the knee kicker on the carpet near the wall in a corner. put it about 3 inches (7.6 cm) out from the wall. hit the flat, vertical part sticking out on the other end with your knee, making sure to apply some force. when you hit it, it tacks the carpet on to the strip. Step 4: prepare the surface. use a hammer, putty knife, and sandpaper to smooth out the surface of the floor by removing any globs of glue, errant nails, or built up paint. after cleaning away the. Pin each piece down with a staple gun or tacks, so it can’t bunch up and slide around as you lay the carpet on top. 7. drop carpet into position. lay the carpet loosely against the longest wall in the room, using one foot to pin it down and the other to push the roll out in front of you. Apply the glue. once your carpet is cut and laid out, fold up the edges so you can spread the glue. be sure to use correctly branded glue to make sure you don’t void the manufacturer’s warranty. apply the adhesive according to the manufacturer’s instructions. allow the adhesive to cure before laying any carpet.
Comments are closed.