How To Drain And Fill Radiator Coolant On 2015 Nissan Quest Youtube This video is about how i drain the old radiator coolant out of the radiator and refill it with new antifreeze and the way i get the air bubbles out of the r. Open radiator cap and rear air relief valve at rear center of engine. 3. remove radiator overflow reservoir, drain and clean with distilled water, reinstall. 4. drain coolant using drain plug at bottom of radiator. 5. pre mix 1 gallon genuine nissan coolant 1 gallon distilled water using a suitable container. 6.
How To Drain And Flush A Radiator And Cooling System We appreciate your interest in nissan and thank you for buying a quality nissan vehicle. however, if there is something that your nissan dealer cannot assist you with or you would like to provide nissan directly with comments or questions, please contact the nissan consumer affairs department using our toll free number: for u.s. customers 1 800. Drain the cooling system. disconnect the negative battery cable. remove radiator lower hose from the engine coolant inlet side. remove engine coolant inlet and thermostat. to install, reverse removal procedure. when installing engine coolant temperature sensor, use genuine rtv silicone sealant or equivalent. This video shows where the radiator drain plug (petcock) is located on a 2012 nissan quest. fill up the radiator with distilled water and run the engine. turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50 50 coolant distilled water mixture and burp the system. The most important bit is not to mix different types of coolant (ie the whole oat hoat xxx discussion). the coolant i drained was the same 'dark green murk' as the nissan oem i boughtt so i was pretty confident i had the right stuff. yeah my $15 came from the canadian peso effect, probably only $10usd difference between prestone and oem.
How To Drain And Flush A Radiator And Cooling System This video shows where the radiator drain plug (petcock) is located on a 2012 nissan quest. fill up the radiator with distilled water and run the engine. turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50 50 coolant distilled water mixture and burp the system. The most important bit is not to mix different types of coolant (ie the whole oat hoat xxx discussion). the coolant i drained was the same 'dark green murk' as the nissan oem i boughtt so i was pretty confident i had the right stuff. yeah my $15 came from the canadian peso effect, probably only $10usd difference between prestone and oem. 4th flush: step 12: once you have decided it is clean enough for you and have done steps 2, 3, 5, 6, and 7 for the last time; you will do steps 8 & 9 with coolant. the '09 manual states the entire coolant system holds 7.75qts (including the .75qt reservoir). to ensure the 50 50 mix you will need to add half of that in concentrate. 1. inspect under the vehicle: park your nissan on a flat surface and let it cool down completely. place a clean piece of cardboard or paper under the engine area. start the engine and let it run for a few minutes. turn off the engine and carefully check the cardboard or paper for signs of coolant leaks. 2.
How To Drain And Flush Radiator Coolant In Under 30 Minutes 4th flush: step 12: once you have decided it is clean enough for you and have done steps 2, 3, 5, 6, and 7 for the last time; you will do steps 8 & 9 with coolant. the '09 manual states the entire coolant system holds 7.75qts (including the .75qt reservoir). to ensure the 50 50 mix you will need to add half of that in concentrate. 1. inspect under the vehicle: park your nissan on a flat surface and let it cool down completely. place a clean piece of cardboard or paper under the engine area. start the engine and let it run for a few minutes. turn off the engine and carefully check the cardboard or paper for signs of coolant leaks. 2.
Comments are closed.