Home Network Rack Build Complete Youtube I was running out of room in my old network rack, so i decided to purchase a new one. in this video i go through a full network rack installation to move my. Sponsored by netgear. the orbi wifi 6e is the industry's first quad band wifi 6e mesh system. for more info ️ bit.ly shaneorbiwifi6emy smart home ne.
Diy Homelab Open Frame Wall Mount Network Rack Youtube Affiliate kit link for items in this video kit.co lawrencesystems home lab or office rack buildmonoprice slimrun cat6 ethernet patch cables compared 2. Step 3: add the mounting bolts. screw in the four 1 4″ mounting bolts to the wall. i highly recommend using flat washers to give it some extra holding power, as the holes in the rack are just a little big for my liking and i was worried the bolt heads might pull through. the plywood i used is 3 4″ cabinet grade pine. To do this you will need to drill a coupe of holes in the rack rails. i have used the really thin 10cm long unifi patch cables. the blue cables are the wan connection and the link between the udm pro and the unifi switch. behind the vented blank panel are all the small network gear, like the modem, pi and smart hubs. On devices you want to manually assign an ip address to, enter it in the device's ip address settings. in windows, this is found by right clicking the network connection and clicking properties. you should match the subnet mask, default gateway, and dns server settings with your router.
Diy Home Rack Build Youtube To do this you will need to drill a coupe of holes in the rack rails. i have used the really thin 10cm long unifi patch cables. the blue cables are the wan connection and the link between the udm pro and the unifi switch. behind the vented blank panel are all the small network gear, like the modem, pi and smart hubs. On devices you want to manually assign an ip address to, enter it in the device's ip address settings. in windows, this is found by right clicking the network connection and clicking properties. you should match the subnet mask, default gateway, and dns server settings with your router. Box for the top half of the rack. the bottom section is full depth 20u, and the top if half ish depth 12u. then, i cut two birch plywood pieces for both horizontal surfaces, clamped them down, and drilled 3 8" holes through the plywood into the 2x4s. glued dowel rods into the 2x4s, and rounded out the holes in the plywood. Home network racks. although not absolutely necessary a home network rack makes a home network installation look professional. racks come as open and closed cabinet. they are 19inches wide and the height is give in units u where 1u=1.75 inches (44.45mm). the example below is 6u high. depth can be important so you need to understand what will go.
Comments are closed.