Flushing Filling The Coolant On A 2001 Toyota Celica Youtube This video goes through the steps on how to bleed the cooling system on the early 2000's toyota celica the proper way!!!i will soon be doing more celica vide. Start your coolant flush by draining the coolant antifreeze that is in your reservoir, then drain the coolant that is in your radiator by opening the petcock or removing the lower radiator hose. this video shows where the radiator drain plug (petcock) is located on a 2001 toyota celica. fill up the radiator with distilled water and run the.
Flushing Filling The Coolant On A 2001 Toyota Celica Youtube However, if the level is on or below the "low" line, add coolant. bring the level up to the "full" line. always use ethylene glycol type coolant for a proper corrosion protection of aluminum components. if the coolant level drops within a short time after replenishing, there may be a leak in the system. visually check the radiator, hoses, drain. 17998 posts · joined 2003. #1 · oct 31, 2005 (edited by moderator) celica coolant bleeding procedure. this is the method i have found to work best for bleeding the coolant at home in the driveway. there are better ways (vacuum system) if you have a fully equipped automotive shop. this is merely my opinion, not an official or approved repair. 1) you dont need to find the engine drain plug. just remove the radiator drain plug, or as suggested, loosen a lower hose and let it drain out. 2) once your done with that plug it up again and dump radiator flush in there and fill the radiator up with water. 3) run the car until it warms up. heater on full blast. Basically, grab another coolant jug. pour half the toyota red in, and fill the rest of the jugs up with water. you should have two gallons of 50 50 mixture. fill up the reservoir until it gets to the cold level. start the car with max heat, fresh air recirculation on (habit i do with every car).
Comments are closed.