Diy Planer Stand With Storage And Folding Outfeed Table How to build the planer stand. step 1: prepare the boards. make the cuts per the cut list in the plans. i cut the 2x4s on the miter saw and the plywood using a circular saw and the straight edge guide. you can also use a table saw for the plywood. make pocket holes in the 2×4 side pieces or aprons. I built a diy planer stand for my thickness planer with storage and a folding outfeed table. i even added outfeed rollers to make it easy to use with longer.
Easy Diy Planer Stand With Storage Folding Out Feed Table And Rollers Cut the front and back of the drawer box to that length, and drill pocket holes on two sides. attach the sides to the front and back with wood glue and pocket hole screws. cut the ¼" plywood to the same size as the bottom of the drawer box, then attach it with wood glue and brad nails. Do this on both the top an bottom sides of the platform. drill a hole through the center using a 3 8 bit. insert the head of the eyebolt into the cavity. slip a 3 8 washer into the recessed hole, followed by a 3 8 hex bolt. slip another 3 8 washer onto the end of the bolt from underneath. add a 3 8 nut. Step 1. cut the lumber down to size. for the frame of this project, we are using 2×4 lumber. step 2. plane the wood. now, normally this isn’t a step that would be required in a build. but we are building a stand for the planer. why not use the planer to freshen up and smooth out the stock 2×4 lumber i’m using to build the stand. – lumber per the plans (2×4 and plywood) – 2 1 2″ pocket hole screws – 1 1 4″ pocket hole screws – 4 locking casters and washer screws – drawer pull – 16″ drawer slides – kreg quick flip.
Comments are closed.