Configure Your Qlogic Nic Using Iwarp Youtube Select that. on the main configuration page we want to go to 'device level configuration' and we want to make sure the 'virtualization mode' is set to 'none'. after doing that we click 'back'. next we want to select 'nic configuration'. for 'link speed' we want to make sure that 'smartan' is selected. Configuring the qlogic nic configure the qlogic network adapter for each port. steps: 1. during system startup, press f2 to enter system setup. 2. click system bios and select device settings. 3. select the qlogic network adapter from the list of adapters. 4. click device level configuration and ensure that virtualization mode is set to none. 5.
How To Configure Your Qlogic Nic Using Iwarp Dell Us Dell microsoft hci deployment: configuring qlogic nic using iwarphere's how to configure qlogic fastlinq network cards as s2d storage adapters using rdma and. This video shows how to configure qlogic fastlinq network cards as s2d storage adapters using rdma and iwarp. these steps are also covered in the dell microsoft hci solutions deployment guide. Perform the following steps to configure the qlogic network adapter for each port. during system startup, press f2 to enter system setup and select device settings. select the qlogic network adapter from the list of adapters. click device level configuration and ensure that virtualization mode is set to none. click back, and then click nic. Reference guide: switch configurations iwarp only (qlogic cards) this guide consists of switch configuration for all for iwarp based deployments for microsoft hci solutions from dell technologies. download pdf.
Comments are closed.