Coding the Future

2012 2014 Hyundai Genesis How To Check Add Coolant Youtube

2012 2014 Hyundai Genesis How To Check Add Coolant Youtube
2012 2014 Hyundai Genesis How To Check Add Coolant Youtube

2012 2014 Hyundai Genesis How To Check Add Coolant Youtube This video shows how to check and add coolant on the hyundai genesis. i use prestone 50 50 pre diluted antifreeze coolant, and it is green color. i noticed t. Follow these simple steps to check and fill your radiator coolant to make sure your vehicle continues to perform at its best. for more updatessubscribe: http.

hyundai Myhyundai how To Check And Fill coolant youtube
hyundai Myhyundai how To Check And Fill coolant youtube

Hyundai Myhyundai How To Check And Fill Coolant Youtube Hello i had to change my coolant so i decided to record it and post it here for you guys, this is how to change the coolant on a 2009 hyundai genesis with th. Add brake fluid. if your brake fluid is a little low, learn how to add some here. ignoring a low level leads to big problems. 2013 hyundai genesis coupe 2.0t premium 2.0l 4 cyl. turbo. be cool under pressure. your coolant should perform well under any condition just like aaron rodgers!. Turn off the engine and allow it to cool down. pop the hood open by pulling the hood release under the hood. find your coolant reservoir on the side of the engine and check the level by looking at the side of the container. you should see a min and max line. if the level is below the minimum level, open the filler cap and add coolant to bring. 3. check the radiator fluid level by looking at the “fill” line. coolant systems don’t normally have a lot of extra room at the top, so the fluid levels should be near the top. if the fluid is more than a few inches from the cap, it’s probably low. look for the “full” or “fill” line etched into the radiator metal.

coolant Change hyundai genesis V8 2009 2014 youtube
coolant Change hyundai genesis V8 2009 2014 youtube

Coolant Change Hyundai Genesis V8 2009 2014 Youtube Turn off the engine and allow it to cool down. pop the hood open by pulling the hood release under the hood. find your coolant reservoir on the side of the engine and check the level by looking at the side of the container. you should see a min and max line. if the level is below the minimum level, open the filler cap and add coolant to bring. 3. check the radiator fluid level by looking at the “fill” line. coolant systems don’t normally have a lot of extra room at the top, so the fluid levels should be near the top. if the fluid is more than a few inches from the cap, it’s probably low. look for the “full” or “fill” line etched into the radiator metal. A check engine light can be cleared with a simple fix or it could be a major problem find out now! 2013 hyundai genesis 3.8 3.8l v6. change a rear blinker. don't send mixed signals if your turn signal doesn't blink, or blinks rapidly, you likely have a burnt out bulb. 2013 hyundai genesis 3.8 3.8l v6. set the clock to the correct time. Coolant flush diy video guide. simple drain and fill antifreeze procedure for all gencoupes! i was able to get about 1 gallon (3.78 l) out from the radiator plus an additional 0.5 l was added to the reservoir so overall 4.3 l was exchanged. don't forget to add distilled to the reservoir then remove it after.

Comments are closed.