2006 2011 2013 2016 Hyundai Santa Fe Engine Coolant Temperature Sensor The engine control module uses the engine coolant temperature (ect) sensor to determine whether or not to trigger a obd ii p0128. when a trouble code p0128 exists by itself, usually a shop technician will suspect a fault engine coolant temperature sensor or stuck open thermostat. a stuck open or prematurely opening coolant thermostat. Hyundai santa fe coolant temperature sensor replacement location removalif you have hyundai santa fe and you need to replace the coolant temperature sensor o.
Hyundai Santa Fe Coolant Temperature Sensor Replacement Location P0118 is a common obdii trouble code. it is a general code, which means that it’s going to have the same meaning for the hyundai santa fe as it would any other vehicle. p0118: engine coolant temp sensor circuit → high input. this code is thrown when the resistance coming from the coolant temp sensor does not change as the vehicle warms up. Service engine soon – other than the heater not working, the only other symptom of p0128 is typically the service engine soon light itself. slight decrease in fuel economy – the p0128 code may also lead to a slight decrease in fuel economy. this is because your santa fe’s engine is running at a cooler temperature than it should be. Hyundai santa fe dm 2013 2018 service manual engine control fuel system engine control system engine coolant temperature sensor (ects). repair procedures repair procedures inspection. This video shows where the radiator drain plug (petcock) is located on a 2013 hyundai santa fe. fill up the radiator with distilled water and run the engine. turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50 50 coolant distilled water mixture and burp the system. like the oil in your santa fe.
Hyundai Santa Fe Code P0115 P0116 P0117 P0118 P0119 Coolant Hyundai santa fe dm 2013 2018 service manual engine control fuel system engine control system engine coolant temperature sensor (ects). repair procedures repair procedures inspection. This video shows where the radiator drain plug (petcock) is located on a 2013 hyundai santa fe. fill up the radiator with distilled water and run the engine. turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50 50 coolant distilled water mixture and burp the system. like the oil in your santa fe. 13. install the radiator cap and fill the reservoir tank to the "max (or f)" line with coolant. 14. run the vehicle under idle until the cooling fan operates 2 ~ 3 times. 15. stop the engine and wait coolant gets cool. 16. repeat 10 to 15 until the coolant level doesn't fall any more, bleed air out of the cooling system. Replace coolant (first, 60,000 miles (96,000 km) or 60 months after every 30,000 miles (48,000 km) or 24 months) 67,500 miles (108,000 km) or 54 months rotate tire inspect battery condition inspect air cleaner filter inspect vacuum hose replace engine oil and filter (2.4 gdi) *6 (67,500 miles (108,000 km) or 108 months).
Hyundai Santa Fe Dm Engine Coolant Temperature Sensor Ects Repai 13. install the radiator cap and fill the reservoir tank to the "max (or f)" line with coolant. 14. run the vehicle under idle until the cooling fan operates 2 ~ 3 times. 15. stop the engine and wait coolant gets cool. 16. repeat 10 to 15 until the coolant level doesn't fall any more, bleed air out of the cooling system. Replace coolant (first, 60,000 miles (96,000 km) or 60 months after every 30,000 miles (48,000 km) or 24 months) 67,500 miles (108,000 km) or 54 months rotate tire inspect battery condition inspect air cleaner filter inspect vacuum hose replace engine oil and filter (2.4 gdi) *6 (67,500 miles (108,000 km) or 108 months).
Hyundai Santa Fe Dm Engine Coolant Temperature Sensor Ects Repai
Comments are closed.