2000 2006 Toyota Tundra Radiator Replacement 4 7l 2uz Fe Toyosolutions Remove the 4 or 5 bolts holding the skid plate on and remove the skid plate. 2) drain the engine coolant. loosen the radiator cap and place a catch pan below the radiator drain plug and loosen the plug to drain the radiator. . 3) disconnect the radiator reservoir hose from the radiator. this is the small hose at the top of the radiator. Brian eslick from how to automotive howtoautomotive takes you step by step through the process of replacing the radiator, thermostat, and radi.
3 Rows Aluminum Radiator For 2000 2006 Toyota Tundra Base Limited Sr5 Use "toyota long life coolant" or equivalent and mix it with plain water according to the manufacturer's directions. use of the coolant which includes more than 50% [freezing protection down to 35°c ( 31°f) ] or 60% [freezing protection down to 50° c ( 58°f) ] of ethylene glycol is recommended, but not more than 70% . Park the vehicle on a good incline (front facing up), set the heater to its highest setting, pull the radiator cap and idle the engine. if there's any air in there, it will gurgle and bubble out the spout. when that stops, and all you're getting is coolant smoothly flowing out, you've bled the system. shut off the engine, add coolant to top off. If necessary, replace the fluid coupling. c. reinstall the fan to the fluid coupling with the 4 nuts. torque: 5.4 nm (55 kgf cm, 47 inch lbs.) 3. inspect fan pulley bracket. check the turning smoothness of the fan pulley. if necessary, replace the pulley bracket. 4. inspect timing belt components. installation. 1. install water pump. a. The toyota 2uz fe is a 4.7l v8 that made its debut in the 1998 land cruiser. the engine offers a solid balance of performance and reliability. though, there is no perfect engine and no exceptions apply here. the 2uz fe is prone to its share of issues including the exhaust manifold, timing belt, and water pump. toyota 2uz fe engine problems.
Comments are closed.